Parker ac890 - Page 403

D-7 Programming
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
ACCESS CONTROL
SETUP::MENUS::ACCESS CONTROL
This function block contains options associated with keypad password protection, view levels, setpoint display and initial
Operator Menu selection.
Parameter Descriptions
VIEW LEVEL
PREF: 31.01
Default: 1
Range: See below
Sets the level of menu to be displayed by the keypad.
Enumerated Value : View Level
0 : OPERATOR
1 : BASIC
2 : ADVANCED
PASSWORD
PREF: 31.02
Default: 0000
Range: 0x0000 to 0xFFFF
Setting a non-zero value enables the password feature.
CONFIG NAME
PREF: 31.05
Default:
Range: See below
The maximum length is 16 characters. When not blank, the string is displayed as the top line of the Welcome screen.
STARTUP SCREEN
PREF: 31.06
Default: 0
Range: See below
Selects which of the Operator Menu parameters will be displayed after the Welcome screen.
Enumerated Value : Startup Screen
0 : selects REMOTE SETPOINT or LOCAL SETPOINT
1 : selects parameter defined by OPERATOR MENU 1
2 : selects parameter defined by OPERATOR MENU 2
: etc.
32 : selects parameter defined by OPERATOR MENU 32