Programming D-22
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
COMMS PORT
SETUP:: SEQ & REF::COMMS PORT
Designed for all Motor Control Modes.
This function block allows you to set the mode for the P3 Comms Port (keypad port).
Parameter Descriptions
Range: Enumerated - see below
Enumerated Value : Mode
0 : AUTOMATIC (senses if either 6511 or 6901 operator station is present)
1 : 6511 OP STATION
2 : 6901 OP STATION
3 : TS8000 HMI
To Next Page
Loading...
