Parker ac890 - Electrical Ratings: 890 SD Frame B, 230 V

E-23 Technical Specifications
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Electrical Ratings: 890SD Frame B, 230V
Input currents are listed at 230Vac at 50Hz. Suitable for use in a circuit capable of delivering not more than 5000 rms Symmetrical
Amperes. Motor power, input current and output current must not be exceeded under steady state operating conditions.
Model Number
890SD-231300B
(890SD/2/0003B)
890SD/2/0005B
(890SD-231550B)
Nominal Supply Voltage
230Vac
230Vac
Motor Power
0.55kW
0.75Hp
1.1kW
1.5Hp
Input Bridge I
2
t (note 1)
A
2
s
100
100
Internal Resistor Power Rating
W
not applicable
not applicable
External Cont. Power Rating (note 2)
W
450
450
External Minimum Resistor Rating
Ω
36
36
Vector Mode
Input Current
A
4.2
7.7
Output Current @ 3kHz (note 3)
A
3
5.5
Power Loss @ 3kHz
W
85
105
Output Current @ 6kHz (note 4)
A
3
5.5
Power Loss @ 6kHz
W
85
110
Output Overload Motoring
150% overload for 60 seconds (all vector modes) 180% for 1s (V/Hz mode)
Servo Mode
Input Current (note 5)
A
4.2
7.3
Output Current @ 4kHz
A
2.2
4
Power Loss @ 4kHz
W
80
95
Output Current @ 8kHz (note 4)
A
2.2
4
Power Loss @ 8kHz
W
80
100
Output Overload Motoring
200% overload for 4 seconds (PMAC mode)
Notes: 1) Based on a 10ms rectangular current pulse. 2) Based on 30% duty at a braking resistor appropriate for braking at 100% of drive rated power.
3) Up to the highest supply voltage that maintains shaft power less than the product power rating, for a typical induction motor. Derated for operation above this supply voltage.
4) Products take less input current when operated in these modes, than stated. 5) Based on a permanent-magnet motor with efficiency 90% and power factor 0.9.