Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
14
Bulletin HY25-1650-M1/US
Installation Sketch
NOTES:
1) Reference Kits:
329255-12X
329601X
2) Caution: Torque Values Must Be Maintained 120-144 In-Lb
3) Strip Wire Ends 0.25" Prior to Installing Connector
Slice Grommet.
Insert in Hole in Clutch
Master Cylinder Seal
Assembly
379817 Grommet
Cut 1.00" Hole in Firewall
Near Ford Clutch Master
Cylinder Seal Assembly
Firewall Pass-through Installation
The Clutch Master Cylinder Seal
Assembly is on the Driver’s Side
Near the Brake Master
Located on the Engine Compart-
ment Firewall Cylinder
Connector and 2-Wire
Shielded Cable
(4.9")
(1.8")
(1.0")
Electrical Ground
of Cab
Accepts 1/4" Screw
16 AWG Wire, Black
Connect to Ground
3/8" Stud Size
Ring Terminal
16 AWG Wire, Red
Connect per
Wiring Chart page 15
Red
Black
See Wiring Chart
page 15
White W/Blue Stripe
Saddle Splice Connector.
Supplied by Installer
16 AWG Wire r
Supplied by Installer
Run Cable through
Grommet in Firewall
Speed Sensor Extension Cable
328923-10X (10 Ft Supplied w/E.O.C.)
328923-5X (5 Ft Optional Cable)
16 AWG Wire, Blue
16 AWG Wire, Green
Connect to Blue Wire from EO.C.
Connect to
Green Wire
from EO.C.
White
Black
Yellow
Black
Red
See Wiring Chart page 15
379243
Speed Sensor
28-P-171
O-Ring
379698
90° Elbow
High Pressure Port
to 5R110 Transmission
2 See Torque Note
379502
Pressure Switch
329232-1X
Hose Assembly
Electronic Overspeed
Controller - 329650X
329599X
Wire Harness
Electronic Over Speed Control (E.O.C.) Installation
Sketch for 247 Series 12 and 24 Volt (SK-474)
Owner’s Manual
Electronic Overspeed Control
Wire “A”
See Chart on
Page 15
To Next Page
Loading...
