EasyManua.ls Logo

Parker CHELSEA - Installation Schematics; E.O.C. Installation for Allison 270;271;800;852 Series (SK-466)

Parker CHELSEA
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
6
Bulletin HY25-1650-M1/US
Installation Sketch
Electronic Over Speed Control (E.O.C.) Installation
Sketch for 270, 271, 800 and 852 Series (Allison) (SK-466)
IN CYL
16 AWG Wire, Red
Connect to 12 VDC or
24 VDC, 5A Minimum
Ignition Circuit
Ground
16 AWG Wire, Black
Ring Connector
Electronic Overspeed
Controller - 329650X
(1.0")
(1.8")
(4.9")
379265
Grommet
Drill 1" Hole
in Firewall
Slice Grommet
Insert Wires and
Push into Hole in
Firewall
NOTE:
1) Strip Wire Ends 0.25" Prior to Installing into Connector
14 AWG Wire, Green
with Butt Connector
14 AWG Wire, Blue
with Butt Connector
Connector with
2-Wire Cable
379254-13
14 AWG Wire, Blue
Bullet Connector
328923-10X
2-Wire Cable 10 Ft. with
Male and Female Connector
328923-5X Optional 5-Ft.
379243
Speed Sensor
Port B
Port C
271 Series P.T.O.
Port A
From Trans to Valve
329087X Pressure Lube Hose
379254-3
14 AWG Wire, Green
with Butt Connector
Ground
379253 14 AWG Ring Connector
18 AWG Wire, Red
379449
Screen Adapter
379258
Bracket
379254-14
14 AWG Wire, Black
with Ring and
Bullet Connector
379547
Pressure Switch
378966
Street Tee
.125"-27 NPTF
379193-1 (12 Volt) Green
379686-2 (24 Volt) Black
Solenoid Valve
From Valve to P.T.O.
5000357-7
Washer
500457-6
Screw
Ground
328075X
Pressure Lube
Hose (2)
Dump Line Back
to Transmission
thru P.T.O.
Owner’s Manual
Electronic Overspeed Control

Related product manuals