Installation and maintenance instructions
GVI Product Manual: Frames C, D & E
42 192-300300N1 GVI Frames C, D & E 2019-9
10. Installation and maintenance
instructions
10.1 Introduction
This chapter contains general instructions for installation and maintenance of the motor controller. Fasteners
and tightening torques for mounting of the motor controller must be specified in accordance with Chapter 7.
Fasteners for connection of the terminal posts on the motor controller must be specified according to chapter
10.6.
The actual procedures for installation and maintenance of the motor controller in a specific vehicle may vary
from what is presented here or include additional steps. It is the responsibility of the vehicle manufacturer to
develop detailed instructions for installation and maintenance of the motor controller in the target vehicle.
CAUTION
Sensitive equipment - risk of damage to equipment
The motor controller contains no user adjustable or user replaceable components beneath its
protective cover. Do not remove the cover.
Do not clean the motor controller using high-pressure water.
NOTE
The maintenance instructions in this chapter are general-purpose procedures that do not
address vehicle-specific requirements. Personnel performing maintenance should consult the
vehicle manufacturer's instructions, which always supersede the instructions in this document.
To Next Page
Loading...
