Parker GVI Series - Terminals with Threads

Installation and maintenance instructions
GVI Product Manual: Frames C, D & E
48 192-300300N1 GVI Frames C, D & E 2019-9
10.6.1. Terminals with threads
Figure 31 shows the assembly order for the terminal connection fasteners.
NOTE
Mount the optional on-board fuse according to chapter 10.6.2.
Pos
Name
GVI Frame C
GVI Frame D
GVI Frame E
1
Screw for terminal B+ (for
optional on-board fuse)
[1 piece]
M6 x L
Screw engagement
8-12.5 mm
Tightening torque
8 ± 1 Nm
M8 x L
Screw engagement
12-16 mm
Tightening torque
15 ± 2 Nm
M8 x L
Screw engagement
8-12 mm
Tightening torque
15 ± 2 Nm
2
Flat washer
[6 pieces]
ISO 7089 12 x 6.4 x 1.6 - 200
HV or similar
ISO 7089 16 x 8.4 x 1.6
- 200 HV or similar
ISO 7089 16 x 8.4 x
1.6 - 200 HV or similar
3
Ring lug
[5 pieces]
6.5 mm hole diameter for
battery and motor
connections
8.5 mm hole diameter
for battery and motor
connection
8.5 mm hole diameter
for battery and motor
connection
4
On-board fuse (optional)
[1 piece]
OEM’s responsibility. See
chapter 7.7.1
OEM’s responsibility.
See chapter 7.7.1
OEM’s responsibility.
See chapter 7.7.1
5
Rectangular washer (for
optional on-board fuse)
[3 pieces]
Tin plated rectangular
copper washer
Tin plated rectangular
copper washer
Tin plated rectangular
copper washer
6
Screw for terminals (Table
12)
[5 pieces]
M6 x L
Screw engagement
8-12.5 mm
Tightening torque
8 ± 1 Nm
M8 x L
Screw engagement
28-32 mm
Tightening torque
15 ± 2 Nm
M8 x L
Screw engagement
12-19 mm
Tightening torque
15 ± 2 Nm
Figure 31 Fasteners for terminal posts with threads