Parker HAS Series - Page 102

Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
103
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois USA
www.parker.com/cylinder
Catalog HY08-4005-M3
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Trip Table
66551111
KKeeyyppaadd
DDiissppllaayy
66990011
KKeeyyppaadd
DDiissppllaayy
DDeessccrriippttiioonn PPoossssiibbllee RReeaassoonn ffoorr TTrriipp
DCHI OVERVOLTAGE
The shared dc link
voltage is too high
The supply voltage is too high
Trying to decelerate a large inertia load too
quickly The brake resistor is open circuit
OC OVERCURRENT
The current being drawn
from the drive is too high
HOT HEATSINK
The heatsink
temperature is too high
IT INVERSE TIME
High output current for
prolonged period,
(warning only)
DISP DISPLAY / KEYPAD
Keypad has been
disconnected from drive
whilst drive is running in
local control
Loose connection to display
SCI LOST COMMS Not used
Refer to Parker Hannifin technical support