Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
97
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois USA
www.parker.com/cylinder
Catalog HY08-4005-M3
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Trip Table
66551111
KKeeyyppaadd
DDiissppllaayy
66990011
KKeeyyppaadd
DDiissppllaayy
DDeessccrriippttiioonn PPoossssiibbllee RReeaassoonn ffoorr TTrriipp
LSPD LOW SPEED OVER I The motor is drawing too
much current (>100%) at
zero output frequency
♦ FIXED BOOST and/or AUTO BOOST set too high
(refer to FLUXING menu at level 3)
PHAS PHASE FAIL
♦ One or more input phases not present
ENC 1 FBK ENCODER
FAIL
♦ Encoder fault
SHRT DESAT (OVER I)
♦ Instantaneous overcurrent. Refer to
OVERCURRENT in this table
DCRP VDC RIPPLE
♦ The dc link ripple voltage is too high. Check for a
missing input phase.
DBSC BRAKE SHORT CCT Brake resistor overcurrent
♦ Check brake resistance is not less than minimum
value allowed
♦ check wiring and brake resistor for earth faults
OSPD OVERSPEED
♦ Speed feedback > 150% for 0.1 seconds
ANIN ANALOG INPUT
ERR
♦ 4-20mA analog input current > 22mA could damage
the input circuit
To Next Page
Loading...
