Parker P1D Series - P1 D Cylinder Configuration and Operation; Air Quality Requirements; P1 D Clean Features

14
P1D Cylinder
05.03
www.parker.com/euro_pneumatic
Operation data
Working pressure Max 10 bar
Working temperature min max
Standard -20 °C +80 °C
High temp version -10 °C +150 °C
Low temp version -40 °C +40 °C
Greased for life, does not normally need additional lubrication. If extra
lubrication is given, this must always be continued.
Bores and strokes
P1D 32 - 125 mm
Standard strokes 25 - 500 mm according to ISO 4393,
see page 17
Max stroke 2800 mm
Min stroke, P1D Clean 25 mm (0-2 sensors)
100 mm (3-4 sensors)
P1D Clean
Protection class Hose-proof in accordance with IP65
Chemical resistance Tested for normally used industrial
detergents, both acid and alkaline
Working medium, air quality
Working medium Dry, filtered compressed air
to ISO 8573-1 class 3.4.3.
Recommended air quality for cylinders
For best possible service life and trouble-free operation, ISO 8573-1
quality class 3.4.3 should be used. This means 5 µm filter (standard
filter) dew point +3 ºC for indoor operation (a lower dew point should be
selected for outdoor operation) and oil concentration 1.0 mg oil/m
3
,
which is what a standard compressor with a standard filter gives.
ISO 8573-1 quality classes
Quality Pollution Water Oil
class particle max con- max. press. max con-
size centration dew point centration
(µm) (mg/m³) (°C) (mg/m³)
1 0,1 0,1 -70 0,01
2 1 1 -40 0,1
3 5 5 -20 1,0
4 15 8 +3 5,0
5 40 10 +7 25
6 - - +10 -
Standard stroke
Standard strokes for all P1D cylinders comply with ISO 4393.
Special strokes up to 2800 mm.
Minimum stroke for P1D Clean is 25 mm with 0-2 sensors and 100 mm with 3-4 sensors.
Order no Cylinder bore = Standard stroke (mm) = Stroke to special order
XXXX = Stroke (mm) 25 50 80 100 125 160 200 250 320 400 500 600 700 800 900 2800
Double acting
P1D-S032MS-XXXX 32
P1D-S040MS-XXXX 40
P1D-S050MS-XXXX 50
P1D-S063MS-XXXX 63
P1D-S080MS-XXXX 80
P1D-S100MS-XXXX 100
P1D-S125MS-XXXX 125