10
P1D Cylinder
05.03
www.parker.com/euro_pneumatic
P1D Tie-Rod
The P1D is available in a tie-rod version, based on the
same high level technology. This future-proof cylinder is
the perfect choice wherever a tie-rod cylinder is needed.
Installation dimensions to international standard
The P1D Tie-Rod complies with ISO 6431, ISO 15552,
VDMA 24562 and AFNOR installation dimension
standards. For customer reassurance world-wide.
Smooth, quiet operation and long service life
All seals and end-of-stroke washers are made from
polyurethane (PUR), the bearings and piston are made
from proven engineering plastics with excellent bearing
properties and the initial greasing at the factory with a
transparent, foodstuffs-approved grease. Altogether this
gives the P1D very long service life and gentle, quiet
operation.
Optimised cushioning
Thanks to the plastic inserts in the end covers, each
cylinder bore has been given an individual flow geometry.
This gives an optimised cushioning, which is quicker and
easier to set and adjust.
Complete accessory programme
P1D offers a complete ISO, VDMA and AFNOR
compatible accessory programme, with a wide range of
piston rod and cylinder mountings for both pivoted and
fixed operation.
”Drop-in” sensor
The P1D Tie-Rod uses ”drop-in” P1D sensors. An
ingenious multi-jointed adapter fixes the sensors in any
chosen position along the stroke.
To Next Page
Loading...
Need help?
General
