35
Constant Pressure: Constant Pressure Filtration:
Execute Display
Mode CONST. PRESSURE
Up Down Select
Select
Exec Edit Prime
Exec
SET: T16 P1: 20.0 psi
Press RUN when Ready
"RUN"
REMOVING TARE WEIGHT
Please Wait
**
FF 0.0 P1 0.0
Q1 0.0 C1 0.0
"Display/Switch"
FF 0.0 P2 0.0
Q2 0.0 C2 0.0
FF 0.0 P3 0.0
Q3 0.0 C3 0.0
"Display/Switch" "Display/Switch"
FF 0.0 P1 0.0 A1 0.0 A2 0.0
P2 0.0 P3 0.0 A3 0.0
"Display/Switch" "STOP"
Q1 0.0 Q2 0.0 FF 0.0 P1 0.0
Q3 0.0 QT 0.0 Q1 0.0 C1 0.0
"Display/Switch"
C1 0.0 C2 0.0 PUMPING STOPPED
C3 0.0 CT 0.0 Press RUN to Finish
"Display/Switch" "EXIT"
T 20.1
Exec Edit Prime
CONSTANT PRESSURE
SCALE INITIALIZATION
Please Wait
CONSTANT PRESSURE
The "Display/Switch" key on the front panel allows you
to change between 3 operational display screens.
Abbreviations are as follows:
P1= Pressure @ P1
P2= Pressure @ P2
P3= Pressure @ P3
RT = Run Time, Min:Sec
CV= Cumulative Volume
FF= Flow Rate (ml/min based on internal cal. curve)
Q1= Filtrate Quantity, Scale 1
Q2= Filtrate Quantity, Scale 2
Q3= Filtrate Quantity, Scale 3
QT= Filtrate Quantity, Total
C1= Collection Rate (gm/min based on scale data)
C2= Collection Rate, Scale 2
C3= Collection Rate, Scale 3
CT= Collection Rate, Total
T = Temperature, Degrees C
A1 = Analog Channel 1
A2 = Analog Channel 2
A3 = Analog Channel 3
Unless a Balance is connected and properly
configured, and the Filtrate Weight Alarm is enabled,
the Q1 value will be replaced with CV.
The "Scale Initialization" and "Removing Tare Weight"
screens will only occur in this case as well. When not
using a balance it is important that you "Re-Cal" the
system for increased accuracy.
To Next Page
Loading...
Need help?
General
