ParTech 740 - Page 34

To Next Page

To Previous Page

740 Portable Suspended Solids

the sensor signal in the zero solution. This can be caused by too clear a calibration

solution, or a fault with the sensor.

Page 34 of 46 172430IM-Iss07 Issue Date 23/10/2014

Main Page

Default Chapter3
- Table of Contents3
1 Introduction7
- General7
- Display7
- Key Pad7
- Sensors7
- Manual Conventions7
2 Basic Operation9
- Switching on and off9
- Measure Mode9
- Measurement Cycle9
- Display9
- Profiles10
3 Configuration11
- Menu Mode11
- Data Entry11
4 User Profiles14
- Presets14
- Example Profile Configuration14
5 Select Profile16
6 New Profile Wizard17
- New Profile Wizard Keys17
- New Profile Wizard Stages17
7 Profile Config19
- Profile Name19
- Profile User19
- Profile Date19
- Measurement Title20
  - 1User Defined Title20
- Display Units20
  - 1User Defined Units20
  - Linked Units21
- Set Damping Range21
8 Profile Advanced Config22
- Lookup Table Mode22
- Adjust X Values22
- Adjust y Values22
- Constant A, B, C22
9 Monitor Config23
- Bleeper23
- Backlight23
- Auto Shutdown23
- Language23
- Change Password23
- Monitor Adv Config24
  - Factory Cal Values (1 to 5)24
- Load Monitor Defaults24
10 Profile Calibration25
- Calibration - General25
- Methods of Calibration25
- Preparing for Calibration26
- Calibration Wizard26
  - Cal Wizard Keys27
  - Cal Wizard Stages27
- Set Zero27
- Set Span28
  - Step 1. Calibration Value Entry28
  - Step 2. Calibrating28
- Take Sample29
- Enter Sample Result30
11 Information31
- Profile Information31
- Software Version31
- Contact Information31
- Battery Status31
- Sensor Input31
12 Instrument Security32
- Lock Instrument32
- Change Password32
13 Error Messages33
- Measurement33
  - Display over Range33
  - Display under Range33
- Sensor33
14 Battery Charging35
- Battery35
- Charger35
15 Maintenance36
- Sensor Replacement36
16 Presets Measurements37
17 User Profile Setup Record38
18 Technical Support39
- Returning Equipment for Repair39
19 Technical Specification (Should be Last Section)40
- Electrical Information40
- Physical Features40
- Software Features40
20 Preparation of Fullers Earth41
21 Preparation of Formazin Turbidity Standard42
- Health & Safety Precautions42
- Method of Preparation42
- Preparation of Dilution's42
- Calibration43
- Storage Life43
22 Declaration of CE Conformity44

ParTech 740 - Page 34

Table of Contents

Related product manuals