740 Portable Suspended Solids
1 Introduction
1.1 General
The 740 Monitor is used for processing and displaying the output signal from a Partech
sensor. It combines a clear display of the measured parameter, a simple user interface,
with good flexibility to enable configuration to satisfy the users needs.
1.2 Display
The 740 display indicates the measured value with large numerals for good visibility
with an additional status line that shows the current settings, battery status and any
faults that are present. The display has a backlight to enable use of the monitor in low
light conditions and also has automatic contrast settings.
The measurement title, units and display range can all be user set to suit the sensor
being used and the application being monitored.
1.3 Key Pad
A six key tactile membrane keypad is used for all configuration and operation of the
740 Monitor; each key has a very positive operation enabling use even whilst wearing
gloves.
1.4 Sensors
The 740 Monitor can be used with the Partech Soli-Tech 10 (ST10).
1.5 Manual Conventions
This instruction manual describes the configuration and operation of the 740 Monitor
and where required includes some information regarding sensors. It is therefore very
important that it is used in conjunction with the relevant sensor instruction manual. All
dimensions stated in this manual are in millimetres unless otherwise stated.
The manual has been written on the basis that the user has a basic knowledge of
instrumentation and an understanding of the type of measurement being made.
Training in the use of the 740 Monitor can be provided by Partech, please contact
Partech for further information
172430IM-Iss07.odt 172430IM-Iss07 Issue Date 23/10/2014 Page 7 of 46
To Next Page
Loading...
Need help?
General
