6. SERVICE
D. HANDLE & GUARD
e-I
2
D. HANDLE
& GUARD
Check handles for tightness on a
regular basis,
and maintain them in
good condition.
1. With 6 mm allen wrench, remove
front handle by removing two
screws from both sides of saw
housing.
2. With an 8 mm wrench, remove
rear handle parts and replace as
needed.
3. With 10 mm wrench, remove
guard and replace parts as
needed.
a
WARNING: To maintain safe
control of the saw, operate the
saw only with handles provided by
the
manufacturer. Holding or
operating the saw in any other
manner could result In serious
injury to the operator.
27
To Next Page
Loading...
