j 7. TROUBLESHOOTING
. ..A. MECHANICAL...
SYMPTOM POSSIBLE CAUSE
REMEDY
Motor seal blown. Saw running backward.
Check
hydraulic hose
connections.
Control valve in wrong
position.
On non-Partner power pack,
check position of control
valve.
Excessive oil flow.
Use power pat that meets
Specifications.
Blade cutting too slowly.
Faulty seal.
Blade turning too slowly.
Replace seal.
Check
remedies
under
“Blade Turning Too Slowly.”
Wrong blade for material.
Change blade.
Insufficient water.
Make certain proper amount
of water is supplied to
blade.
Difficulty in making roller
adjustment.
Adjustment bushing stuck.
Remove, clean and grease
adjustment bushings.
Loose steel bushings in
roller cover.
Loctite in place.
-
47
To Next Page
Loading...
