Power On by Ring
Use this item to enable modem activity to wakeup the system from a power saving mode.
Resume by Alarm
When set to Enabled, the following two elds become available and you can set the date (day of the month),
hour, minute and second to turn on your system. When set to 0 (zero) for the day of the month, the alarm will
power on your system every day at the specied time.
Date (of Month) Alarm
When set to “0” the system powers on everyday at the time specied in the “Time (hh:mm:ss) Alarm” eld.
Select a date from 1 to 31 for the system to power on at the time specied in the “Time (hh:mm:ss) Alarm”
eld.
Time (hh:mm:ss) Alarm
Set the time for the system to power on as dened in the ‘Date (of Month) Alarm” eld. The time set in this
eld must be later than the time in the RTC time as shown in the “Standard CMOS Features” on page 9.
** Reload Global Timer Events **
Primary IDE0
When the primary master HDD is working, the system timer will be re-loaded and the system will not go into
suspend mode.
Primary IDE1
When the primary master HDD is working, the system timer will be re-loaded and the system will not go into
suspend mode.
Secondary IDE0
When the primary master HDD is working, the system timer will be re-loaded and the system will not go into
suspend mode.
Secondary IDE1
When the primary master HDD is working, the system timer will be re-loaded and the system will not go into
suspend mode.
PCI PIRQ[A-D]#
When the PCI PIRQ[A-D]# has been alerted, the system timer will be re-loaded and the system will not go
into suspend mode.
To Next Page
Loading...
