7 Status
22 99E13331xx-mub-en - V08 2022/07
7 Status
The menu item
Status
contains submenus which allow to
look through all measured/balance values, temperatures
and flow rates at the sensors, relay states, operating
times, heat quantity, tap performance as well as error
messages. In addition, the current firmware is displayed
at the item
Controller.
7.1 Measured and balance values
This menu item contains the information of all current
measured values of the sensors, their minimum and
maximum measured values as well as the states of the
relays (R1, R2, R3).
The minimum and maximum measured values can be
reset by pressing the operating button
Confirm.
In addition, the current operating times, the cycles of
operation, the heat quantity and the tap performance are
recorded and are displayed in the corresponding
submenus. An example is shown in the illustration.
The heat quantity and the tap performance are shown in the following periods of time:
• Current value
• Day (is reset at 00:00 a.m.)
• Week (is reset each Monday at 00:00 a.m.)
• Month (is reset at the first day of the month at 00:00 a.m.)
• Total
In addition, you can reset the data of the periods of time via the
Confirm
button.
To Next Page
Loading...
