PAW FC3.10 - Mounting and Installation [Specialist]]; Installation of the Controller

3 Mounting and installation [specialist]]
2022/07 99E13331xx-mub-en - V08 9
3 Mounting and installation [specialist]]
3.1 Installation of the controller
NOTICE
The following section describes only the installation of the controller.
Follow the instructions of each respective manufacturer when installing external components
(valves etc.). Do not put the controller into operation in case of any visible damage.
1. Temperature sensors
S1-S4 (Pt1000)
2. Flow sensors
(VFS/US)
3. Outputs PWM
4. Modbus (RS 485)
5. RS 232
6. Outputs 230 V
7. Supply
8. Position of the jumper
9. Fuse