PAW FC3.10 - Commissioning; Software Update; Display

10 General settings
26 99E13331xx-mub-en - V08 2022/07
10.6 Commissioning*
Opens the commissioning menu to go through the settings again.
*Settings only visible with installer code (see chapter "User code").
10.7 Software update
To update the firmware, a USB flash drive with the new software on it must be connected to the
USB port. After that, the update can be started via this menu item. This can take 5 minutes.
10.8 Display
The submenu contains all settings to adjust the display to your individual needs. Here you can
adjust parameters like luminosity, contrast and inversion of colours. In addition to that, you can
activate the screen lock. After activating the screen lock, the screen is locked after a determined
period and accessing the menu of the controller is only possible after entering the set PIN code.
Parameters
Meaning
Adjustment range
Factory setting
Language Selection of the menu
language
German, Polish,
English, French,
Spanish, Italian, Dutch,
Swedish
German
Date Setting the date - -
Time Setting the time - -
Synchronise date /
time
Synchronisation of the
date / time (Internet
module is required)
Yes, No No
Auto. Daylight saving
time / standard time
Activate the automatic
change to daylight
saving time / standard
time
Yes, No Yes
Commissioning* Submenu of the
commissioning
- -
Software update Start updating - -
Display Submenu for settings
of the display
- -
Luminosity Setting the luminosity 1 … 100 % 80 %
Luminosity
dimmed
Setting the dimmed
luminosity
1 … 100 % 50 %