PAW FC3.10 - Page 31

14 Automatic/manual mode
2022/07 99E13331xx-mub-en - V08 31
The manual mode has the highest priority.
These setting values overwrite the automatic actuating
values of the controller.
If the controller runs in manual mode, a hand symbol is
shown on the display of the system overview.
Parameters
Meaning
Adjustment range
Factory setting
Automatic mode Sets all outputs to
automatic / manual
mode
On (automatic), Off
(manual mode)
On
Sensor simulation Goes to the submenu to
the simulation of the
inputs
- -
Sensor 1 Sensor 1 (T-FL) Automatic, simulation
(-30 ... 150 °C)
Automatic
Sensor 2 Sensor 2 Automatic, simulation
(-30 ... 150 °C)
Automatic
Sensor 3 Sensor 3 Automatic, simulation
(-30 ... 150 °C)
Automatic
Sensor 4 Sensor 4 (T-CW) Automatic, simulation
(-30 ... 150 °C)
Automatic
VFS/US V VFS/US flow rate Automatic, simulation
(0.0 ... 40.0 l/min)
Automatic
VFS/US T VFS/US temperature Automatic, simulation
(-30 ... 150 °C)
Automatic
Relay 1 Relay 1 Automatic, manual mode
(on, off)
Automatic
Relay 2 Relay 2 Automatic, manual mode
(on, off)
Automatic
Relay 3 Relay 3 Automatic, manual mode
(on, off)
Automatic
PWM 1 PWM control of the
primary pump
Automatic / manual mode
(0.0 ... 100 %)
Automatic
PWM 2 PWM control of the
circulation pump
Automatic / manual mode
(0.0 ... 100 %)
Automatic