Pearpoint Flexitrax P550c - Equipment Settings

P550c Operation Manual
5 System setup
www.pearpoint.com | 110
Equipment settings
This menu is shown automatically when you power up a system (see page 135) except for the first time
when the Set-up Wizard is shown (see page 94).
Note: If the Equipment versions item shows in red, the P550c controller has a newer version of software
for one of system components than is currently installed on that component.
 Drum type: If the drum is powered up, the P550c controller will automatically display whether you have a
powered or manual drum connected.
 Tractor type: If the drum is switched on and power is reaching the tractor, the P550c controller will
automatically display whether you have a steerable or non-steerable tractor connected.
 Tractor wheel size: Enter the wheel size correctly to ensure that distances are measured correctly.
Caution: Setting the wrong wheels will affect drum speed when retrieving and may cause the crawler to
topple. Additional wear and tear may also be caused to drum, tractor, or both.
 Camera type: If the drum is switched on and power is reaching the camera, the P550c controller will
automatically display the camera type connected.
 Powered elevator: If the drum is switched on and power is reaching the tractor, the P550c controller will
automatically display whether you have a powered elevator connected.
 Lighthead: If the drum is switched on and power is reaching the camera, the P550c controller will
automatically display whether a lighthead is detected or not.