17
2018-05-30 #:180-9116-7 (2020-08-04)
Power On/O The Display
Power on your display by using the remote control or the power button on the bottom, left-hand
side of the display. The display will power on but image may not appear for several seconds as it
completes its power up sequence.
OPERATING INSTRUCTIONS
Onboard Controls
Direct Mode: Allows for quick access to source selection, volume settings and channel selection.
Menu Mode: Press the Menu button to access Menu Mode and activate the On Screen Display
(OSD). For a description of OSD operation refer to the next section.
The keypad buttons are assigned as indicated in the table below.
Point the remote control at the IR sensor located
at the top, left-hand corner of the display when in
landscape, or the top right-hand corner when in
portrait, then press the power button.
POWER
TV
TV/SPK
SPK
1 32
4 65
7
•
9
LAST
8
0
OK
AUX1 AUX2
MUTE
VOL
MENU
INFO
INPUT
EXIT
LED Light TV Status
Solid
Blinking Boot up
On
Direct Mode Menu Mode
Input Select Input Select
Menu Return
Channel Up Up
Channel Down Down
Volume Up Right/OK
Volume Down Left/OK
To Next Page
Loading...
Need help?
General
