ECP300 EXPERT
Pag. 18
USE AND MAINTENANCE MANUAL
FRONT PANEL CONNECTION
Hook front panel and reconnect the electronic card connector as indicated below.
Fig.12: Hook the frontal panel back up to the
lower part of the box by inserting the
two hinges in their seats.
Fig.13: Bend the hinges and rotate the front
panel downwards 180° to gain access
inside the panel and then reconnect
the electronic card connector.
.
Fig.13: In case panel is connected with
TeleNET or Alarm/Aux relay is used
wirings must be done directly on the
electronic card clamps.
It’s suggested to put that wirings
beside the connection cables from
electronic card and bottom of the box.
For further clarification on the clamps
please refer to the chapter “TeleNET
SUPERVISING AND MONITORING
SYSTEM”.
CHAP. 3 - Installation
To Next Page
Loading...
Need help?
General
