ECP300 EXPERT
Pag. 19
USE AND MAINTENANCE MANUAL
Rev. 01-12
VERIFICATIONS BEFORE USE
After doing the wirings, please verify using the wiring diagram on the
correct execution of the connections.
Please check the correct screw clamping.
Check, when possible, the correct functioning of the outside protection
devices.
Please correctly calibrate the motor circuit breaker (if present) dedicated
to the compressor as indicated in the next chapter.
After powering the electrical panel please check the correct current
absorption on the loads, and after few hours of functioning check the
good tightening of screws on terminal blocks (included power supply line
connection). Warning: before doing that it’s necessary to cut off power
sectioning power supply upstream the line and block it with a padlock for
max. safety. Before any operation verify with a tester the absence of
voltage.
CHAP. 3 - Installation
To Next Page
Loading...
Need help?
General
