11
TAURUS™ VS Variable Speed Pump Installation and User’s Guide
Quick Clean
The Taurus™ VS Variable Speed Pump is equipped
with a Quick Clean feature, which can be engaged
to temporarily run at higher or lower speeds ranging
between 300 to 3450 RPM. Once the Quick Clean
duration has elapsed, the pump will automatically
return to the programmed schedule.
Programming Quick Clean:
1. Stop the pump if it is running by pressing the
Start/Stop button.
2. Press the Quick Clean button. The LED
above the Quick Clean button and the “Speed”
parameter LED will flash while editing. See
Figure 11.
3. Use the “+” and “-” arrows to adjust the speed in
RPM for Quick Clean.
4. Press the Quick Clean button again and the
display will change to Quick Clean duration. The
“Duration” parameter LED will flash while editing.
See Figure 12.
Note: The Quick Clean feature does not have a
start time.
5. Use the “+” and “-” arrows to adjust the duration
in hours and minutes for Quick Clean.
6. Press the Start/Stop button and ensure the LED
is illuminated. The pump is now on and will run
the speed and duration set for Quick Clean.
Note: When the Quick Clean duration ends, the pump
resumes the 24 hour schedule at the point where it
normally would be running at that time. The Quick
Clean duration will not affect the start or stop times
of the 24 hour schedule. For example, if Quick Clean
runs during a period overlapping with a later part of
SPEED 1 and an early part of SPEED 2, the start time
of SPEED 3 is not affected.
Note: Pressing/Holding Quick Clean key for more than
three (3) seconds will cancel Quick Clean mode.
Note: During the Quick Clean mode, the pump will not
start with the priming sequence.
Note: It is recommended that you do not set the Quick
Clean duration to 0 HRS. Setting the Quick Clean
duration to 0 HRS will not allow you to change the
duration setting while the motor is running. The motor
will have to be stopped in order to change the Quick
Clean settings if the duration is set to 0 HRS.
Keypad Lockout
The pump’s user interface has a Keypad Lockout feature
to prevent unwanted changes to the settings. When
locked, the keypad will only accept input from pressing
the Display button to cycle the displayed information on
the screen and input to stop the motor from a press of
Start/Stop button.
The keypad can be locked by pressing and holding the
“1” button and the Quick Clean button at the same time
for at least three seconds. “Loc On” will be displayed
if successful.
To unlock the keypad press and hold the “1” button and
the Quick Clean button at the same time for at least three
seconds. “Loc OFF” will be displayed if successful.
Note: While operating in Keypad Lockout mode the motor
can still be stopped by pressing the Start/Stop button.
However, the motor can not be started again until the
user unlocks the keypad.
3450
Figure 11: Setting Speed for Quick Clean
2
:
00
Figure 12: Setting Duration for Quick Clean
Key lockout will not prevent the motor from being
stopped by pressing the Start/Stop button. It will
then be unable to be restarted until the keypad has been unlocked. If
the motor is operating in Keypad Lockout mode, and being controlled
through external controls, it can only run when the Start/Stop LED is
illuminated.
To Next Page
Loading...
Need help?
General
