12
TAURUS™ VS Variable Speed Pump Installation and User’s Guide
Factory Reset
The drive can be reset to factory settings if
necessary. A Factory Reset will wipe out all of the
saved user settings that have been programmed,
except for the time of day. Be sure that it is
necessary before performing a Factory Reset, as the
results are immediate.
To perform a Factory Reset:
1. Stop the pump if necessary by pressing the
Start/Stop button.
2. Record all of the custom schedule settings using
Table 3. You can find these setting by pressing
the “1”, “2”, “3”, and “Quick Clean” buttons and
cycling through all the screens. Also write down
the Priming Speed.
3. Press and hold the “1”, “2”, “3”, and “Quick
Clean” buttons for 3 seconds.
4. The screen will display “FACt rSt” if factory
reset is successful. See Figure 13.
5. Be sure to reprogram the schedule and priming
speed after the factory reset. The pump must
be turned back on with the Start/Stop button
before it will run again. The pump will run the
programmed schedule upon initial start-up.
Note: Factory Reset can not be performed from
a Keypad Lockout state.
Speed
(RPM)
Duration
(Hours)
Start Time
(Time Clock)
SPEED 1
SPEED 2
SPEED 3
QUICK
CLEAN
Priming
Speed
Table 3: User Programmed Schedules
Figure 13: Drive Factory Reset
FACt
rSt
To Next Page
Loading...
Need help?
General
