Pentax KC-01 - Page 138

136
Shooting Settings
5
3 Use the four-way controller (45)
to select [Auto], [HDR 1], [HDR 2],
[HDR 3] or [Off], and press the
4 button.
The camera returns to the control panel.
• You can also set the [Auto Align] setting
from [HDR Capture] in the [A Rec. Mode
1] menu.
• When both [Shake Reduction] and [Auto Align] are activated, take note of the
following points.
- Make sure to hold the camera firmly so that the composition of the picture
does not change while the three images are captured. If there is a great
difference of the composition between three images, Auto Align may not be
possible.
- Images captured with HDR Capture are susceptible to camera shake and
blur. Be sure to set a higher shutter speed and a higher ISO sensitivity.
- When the sensitivity is set to [ISO AUTO], the sensitivity can be raised
more easily than normal.
- Auto Align may not be possible when the lenses that have a focal length
exceeding 100 mm is used, or when the entire subject is checkered or has
a uniform surface.
•In Z (Night Scene HDR) of H mode, [HDR Capture] is fixed to [Auto] and
[Auto Align] is fixed to O (On).
• If [One Push File Format] is assigned to the d (G/R) button, pressing the d
(G/R) button temporarily deactivates HDR Capture and saves captured
images in RAW+.
HDR Capture
HDR Capture
Auto
Auto
OK
OK
OK
Cancel
Cancel
MENU
MENU
HDR Capture
HDR Capture
HDR Capture
HDR Capture
Auto Align
Auto Align
P
Does not use Auto Align.
Deactivates Shake Reduction.
(default setting)
O
Uses Auto Align. Activates
Shake Reduction according to
the [Shake Reduction] setting.