41
BASIC OPERATION
(PREPARATION)
BASIC OPERATION
(SHOOTING)
ADVANCED OPERATIONS
OTHERS
✍
MEMO
• The shutter cannot be released if the subject is out of focus.
• Depress the shutter release button halfway down. While lights on,
the camera-to-subject distance is fixed (Focus lock). To refocus on
another subject, lift your finger off the shutter release button.
• When the camera senses subject movement during the autofocus
operation, the camera will automatically switch the focus mode to the
predictive autofocus mode to measure the speed of a moving subject,
and predict where it will be at the moment of shutter release to
maintain sharp focus on the subject.
The focus indicator blinks when the camera is not able to
obtain proper focus for one of the following reasons.
1.The subject is too close. Adjust the camera-to-subject distance.
2.The subject is difficult to autofocus. See "HARD-TO-
AUTOFOCUS" subject on page 74.
4 When the subject is in focus,
the focus indicator in the
viewfinder lights up.
5 Take a picture.
Gently depress the shutter
release button completely.
The built-in flash pops up
automatically when the subject is
not lighted adequately.
To Next Page
Loading...
Need help?
General
