This camera automatically reads the film speed from the film's
DX code. However, the film speed setting can be changed. If you
use a non-DX coded film, set the film speed manually.
How to set
1 Load the Non-DX coded
film.
Move the select dial until
blinking appears on the
LCD panel while depressing
the exposure mode button.
will stop blinking and stays
on when you take a finger off
from the exposure mode button.
2 Move the select dial to set
ISO film speed displayed on
the LCD panel.
3 After ISO film speed is set, move the select dial to
set your desired exposure mode while depressing
the exposure mode button.
✍
MEMO
• To change the ISO film speed, move the select dial to left for a smaller
number (Slower film speed), or right for a larger number (Faster film speed).
• The shutter cannot be released when ISO film speed is displayed on
LCD panel.
• will display when DX coded film speed is set other than DX coded
film speed in used.
75
BASIC OPERATION
(PREPARATION)
BASIC OPERATION
(SHOOTING)
ADVANCED OPERATIONS
OTHERS
SETTING THE FILM SPEED (ISO)
MANUALLY
To Next Page
Loading...
Need help?
General
