56
2
Common Operations
In this manual, the capture mode, such as for taking still pictures, is
referred to as “A mode” (the capture mode). The playback mode, such
as for viewing the captured images on the display, is referred to as “Q
mode” (the playback mode). In Q mode, you can perform simple editing
operations on the captured images.
Follow the procedure below to switch between A mode and Q mode.
1
Press the Q button.
The camera switches to Q mode.
1
Press the Q button or the shutter release button
halfway.
The camera switches to A mode.
Switching Between A Mode and Q Mode
To Switch from A Mode to Q Mode
To Switch from Q Mode to A Mode
Displaying the data stored in the built-in memory
When an SD Memory Card is inserted in the camera, images, movies,
and sounds on the SD Memory Card are displayed. If you want to
display images, movies and sounds in the built-in memory, turn the
camera off and remove the SD Memory Card, or follow the procedure
below to use the “Built-in memory display” function.
Viewing images in the built-in memory while the SD Memory Card is
inserted (built-in memory display)
When you press and hold down the Q button for more than one second in
A mode, the lens is retracted. After the message [Displays image/sound
from built-in memory] appears, images, movies and sound files stored in the
built-in memory are displayed.
• In the built-in memory display, you can play back still pictures (including
enlarged display) (p.132, p.143), movies (p.133) and sounds (p.182), and
switch between four-/nine-image display, folder display and calendar
display (p.134).
• In the built-in memory display, you cannot delete data, delete a selection,
display the Playback Mode Palette or display the menu. If you want to
perform any of these operations on images, movies or sounds in the built-
in memory, do so after removing the SD Memory Card.
Make sure that the camera is turned off before inserting or removing
the SD Memory Card.
To Next Page
Loading...
Need help?
General
