86
Taking Pictures
4
You can switch the Drive mode to Multi-exposure mode. You can overlap
multiple frames while creating a single picture.
1 Press the four-way controller (2) in Capture mode.
2 Press the four-way controller (45)
to select (Multi-exposure).
3 Use the four way controller (23) to
specify the number of shots.
You can specify between 2 and 9 picture-
shots.
4 Press the OK button.
5 Press the shutter release button halfway.
The focus frame on the display will light green when the camera is in
focus.
6 Press the shutter release button fully.
7 Repeat step 5 and 6 for the specified number of shots.
Shooting in Multi-exposure Mode
• When you select , you can use (2 sec. Self-timer), which
enables you to take a picture two seconds after the shutter release
button is pressed, or use the Remote Control (optional) to release
the shutter, to reduce camera shake and blurring.
•
To cancel Multi-exposure shooting halfway, change the Drive mode.
• When you cancel Multi-exposure shooting before the specified
number of shots are taken, the pictures already taken will not be
recorded.
• When shooting in Multi-exposure mode, the recorded pixels are
fixed to 5M. (When using the Half-length Portrait together with
Multi-exposure, the recorded pixels are fixed to 3M.)
Shutter release button
Four-way controller
OK button
OK
Number of Shot 3
Number of Shot 3
OK
OK
Drive Mode
Multi-exposure
Drive Mode
Multi-exposure
MENU
Cancel
To Next Page
Loading...
