USER MANUAL
Peplink Balance Series
http://www.peplink.com - 121 - Copyright © 2010 Peplink
19.6 UPnP / NAT-PMP
The table that shows the forwarded ports under UPnP and NAT-PMP protocols is located at Status >
UPnP / NAT-PMP:
This section appears only if you have enabled the function of UPnP / NAT-PMP as mentioned in Section
13.3.
Click the button
to delete the single UPnP / NAT-PMP record in its corresponding row. To delete all
records, click Delete All on the right-hand side below the table.
Important Note
UPnP / NAT-PMP records would be deleted immediately after clicking the button or Delete All without the
need to click Save or Confirm.
19.7 Event Log
Event Log information is located at: Status > Event Log
The log section displays a list of events that has taken place on the Peplink Balance unit. Click the
Refresh button to retrieve log entries again. Click the Clear Log button to clear the log. Select 50, 100,
or all to show the corresponding number of events in the log.
To Next Page
Loading...
Need help?
General
