USER MANUAL
Peplink Balance Series
http://www.peplink.com - 45 - Copyright © 2010 Peplink
10.1.3 PPPoE Connection
This connection method is suitable if ISP provides login ID / password to connect via PPPoE.
PPPoE Settings
PPPoE User Name
/ Password
Enter the required information in these fields in order to connect via PPPoE to the
ISP. The parameter values are determined by and can be obtained from the ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Service Name
(Optional)
Service Name is a PPPoE parameter which is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
DNS Servers
Each ISP may provide a set of DNS servers for DNS lookups. This setting
specifies the DNS (Domain Name System) Servers to be used when a DNS
lookup is routed through this connection.
Selecting Obtain DNS server address automatically results in the DNS Servers
assigned by the PPPoE server to be used for outbound DNS lookups over the
WAN connection. (The DNS Servers are obtained along with the WAN IP address
assigned from the PPPoE server.)
When Use the following DNS server address(es) is selected, you can put
custom DNS server addresses for this WAN connection into the DNS server 1
and DNS server 2 fields.
Please refer to Section 10.2, 10.3, 10.4, and 10.5 for details about WAN Health Check, Bandwidth
Allowance Monitor, Additional Public IP Settings, and Dynamic DNS Settings respectively.
Note
PPPoE connection made from a firewall does not work with Drop-in mode.
To Next Page
Loading...
Need help?
General
