USER MANUAL
Peplink Balance Series
http://www.peplink.com - 70 - Copyright © 2010 Peplink
13.2 Inbound Access Services
13.2.1 Definition of Services
Services are defined at: Network > Inbound Access > Services
Tip
At least one server must be defined before services can be added.
To define a new service, click the Add Service button, upon which the following appears:
Services Settings
Enable
This setting specifies whether the inbound service rule takes effect.
When Yes is selected, the inbound service rule takes effect. If the inbound traffic matches
the specified IP Protocol and Port, action will be taken by Peplink Balance based on the
other parameters of the rule.
When No is selected, the inbound service rule does not take effect. Peplink Balance will
disregard the other parameters of the rule.
Service Name
This setting identifies the service to the System Administrator.
Valid values for this setting consist only of alphanumeric and the underscore “_” characters.
To Next Page
Loading...
Need help?
General
