USER MANUAL
Peplink Balance Series
http://www.peplink.com - 125 - Copyright © 2010 Peplink
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a Peplink Balance unit, perform the following:
For Balance 210/310:
1. Locate the reset button on the Peplink Balance unit.
2. With a paper clip, press and keep the reset button pressed for at least 10 seconds, until the unit
reboots itself.
For Balance 380/390/580/710/1350:
Use the buttons on front panel to control the LCD menu to go to Maintenance > Factory Default,
and then choose Yes to confirm.
Afterwards, the factory default settings will be restored.
Important Note
All user settings will be lost after restoring the factory default settings.
Regular backup of configuration parameters is strongly recommended.
To Next Page
Loading...
