peplink 210

To Next Page

To Previous Page

USER MANUAL

Peplink Balance Series

Settings for HTTP:

Settings for SMTP:

Set the weight of

WAN1 and WAN2 for

HTTP to 3 and 4,

respectively

Set the weight of

WAN1 and WAN2

for SMTP to 1 and

8, respectively

Main Page

Default Chapter2
- Table of Contents2
1 Introduction and Scope5
2 Glossary6
3 Product Features7
- Supported Network Features7
- Other Supported Features8
4 Package Contents9
- Peplink Balance 210 / 3109
- Peplink Balance 380 / 390 / 580 / 710 / 13509
5 Peplink Balance Overview10
- Peplink Balance 21010
- Peplink Balance 31012
- Led Indicators12
- Peplink Balance 380 / 39014
- Peplink Balance 58017
- Peplink Balance 71020
- Peplink Balance 135023
6 Installation26
- Preparation26
- Constructing the Network26
- Configuring the Network Environment27
7 Basic Configuration28
- Connecting to Web Admin Interface28
- Configuration with Setup Wizard29
- Advanced Setup32
8 Configuration of Lan Interface33
9 Drop-In Mode37
10 Configuration of Wan Interface(S)40
- Connection Method(S)40
  - Static Ip Connection44
  - Pppoe Connection45
- WAN Health Check51
- Bandwidth Allowance Monitor54
- Additional Public IP Settings55
- Dynamic DNS Settings56
11 Site-To-Site Vpn57
- Site-To-Site VPN Settings57
- Peplink Balance Behind NAT Router60
- VPN Status61
12 Management of Outbound Traffic to Wan62
- Outbound Policy63
- Custom Rules for Outbound Policy64
13 Inbound Access69
- Definition of Servers on LAN69
- Inbound Access Services70
- Upnp / NAT-PMP Settings72
- Definition of DNS Records73
  - Ptr Record78
  - Dns Record Import Wizard81
14 Nat Mappings83
15 Qos84
- User Groups84
- Bandwidth Control84
- Application86
16 Firewall88
- Outbound and Inbound Firewall88
- Intrusion Detection and Dos Prevention92
17 Miscellaneous Settings93
- High Availability93
- PPTP Server96
- Service Forwarding97
- Service Passthrough100
18 System Settings101
- Admin Security101
- Firmware Upgrade104
- Time105
- Email Notification106
- Remote Syslog108
- Snmp109
- Reporting Server111
- Configuration113
- Flash Management114
- Reboot115
- Ping Test116
- Traceroute Test117
19 Status118
- Device118
- Active Sessions119
- Client List119
- WINS Client120
- Site-To-Site VPN120
- Upnp / NAT-PMP121
- Event Log121
- Bandwidth122
Appendix A. Restoration of Factory Defaults125
Appendix B. Routing under Dhcp, Static Ip, and Pppoe126
- Routing Via Network Address Translation (NAT)126
- Routing Via IP Forwarding127
Appendix C. Case Studies128
- Performance Optimization128
- Maintaining the same IP Address Throughout a Session130
- Bypassing the Firewall to Access Hosts on LAN131
- Inbound Access Restriction132
- Inbound Access Restriction133
Appendix D. Troubleshooting134
Appendix E. Product Specifications136
- Peplink Balance 210 and 310136
- Peplink Balance 380 and 390137
- Peplink Balance 580138
- Peplink Balance 710139
- Peplink Balance 1350140

Table of Contents

Related product manuals