peplink balance 20

To Next Page

To Previous Page

USER MANUAL

Peplink Balance Series

Cellular Settings

8.4.1.1

Network

Selection

8.4.1.2 By default, the router will automatically select the cellular network. Click on the

button to enable manual network selection.

3G/2G

Band selection to restrict cellular on a particular band. Click on the button to enable the

selection of specific bands.

Authentication

Choose from Auto, PAP Only, or CHAP Only to authenticate celluarl connections.

Band Selection

Choose bands to restrict cellular traffic to those bands.

Data Roaming

This checkbox enables data roaming on this particular SIM card. Please check your service

provider’s data roaming policy before proceeding.

Operator

Settings

This setting applies to 3G / EDGE / GPRS modems only. It does not apply to EVDO / EVDO

Rev. A modems.

This allows you to configure the APN settings of your connection. If Auto is selected, the

mobile operator should be detected automatically. The connected device will be configured,

and connection will be made automatically afterwards. If there is any difficulty in making a

connection, you may select Custom to enter your carrier’s APN, Login, Password, and Dial

Number settings manually. The correct values can be obtained from your carrier. The default

peplink balance 20 - Page 70