USER MANUAL
Peplink Balance Series
http://www.peplink.com -71 / 261 - Copyright © 2015 Peplink
and recommended value for Operator Settings is Auto.
APN /
Username /
Password /
SIM PIN
When Auto is selected, the information in these fields will be filled automatically. Select
Custom to customize these parameters. The parameter values are determined by and can be
obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the “Enable” box to enable bandwidth usage monitoring on this WAN connection for
each billing cycle. When this option is not enabled, bandwidth usage of each month is still
being tracked, but no action will be taken.
If Email Notification is enabled, you will be notified by email when usage hits 75% and 95%
of the monthly allowance.
If Disconnect when usage hits 100% of monthly allowance is checked, this WAN
connection will be disconnected automatically when the usage hits the monthly allowance. It
will not resume connection unless this option has been turned off or the usage has been reset
when a new billing cycle starts.
This option allows you to define which day of the month each billing cycle begins.
This field is for defining the maximum bandwidth usage allowed for the WAN connection each
month.
When this IP Passthrough option is active, after the cellular WAN connection is up, the
router's DHCP server will offer the connection's IP address to one LAN client. All
incoming or outgoing traffic will be routed without NAT.
Regardless the WAN connection's state, the router always binds to the LAN IP address
(Default: 192.168.50.1). So when the cellular WAN is connected, the LAN client could
access the router's web admin by manually configuring its IP address to the same
subnet as the router's LAN IP address (e.g. 192.168.50.10).
Note: when this option is firstly enabled, the LAN client may not be able to refresh its IP
address to the cellular WAN IP address in a timely fashion. The LAN client may have to
manually renew its IP address from DHCP server. After this option is enabled, the
DHCP lease time will be 2 minutes. I.e. the LAN client could refresh its IP address and
access the network at most one minute after the cellular WAN connection goes up.
This option allows you to choose whether to remain connected or disconnect when this
WAN connection is no longer in the highest priority and has entered the standby state.
To Next Page
Loading...
