Enter the LAN IP address and subnet mask to assign to your access point on the LAN.
Check to enable the DHCP server feature of your access point. Enabling DHCP is the
best option for most users. The following options will be enabled once you have checked
and enabled the DHCP server.
Enter the first and last IP addresses of the range of addresses that your access point will
make available to DHCP clients. The default range is from 192.168.1.100 to
192.168.1.200, with 24-bit subnet mask.
Enter the broadcast address that DHCP clients will use when communicating with the
entire LAN segment. The default value is 192.168.1.255.
Enter the default gateway address that DHCP clients will use to access the internet. By
To Next Page
Loading...
Need help?
General
