Basic Installation
23
Basic Installation
Overview
For spectrometers with installation, the initial installation will be performed by a
PerkinElmer service representative. After receipt of the instrument, please contact
your PerkinElmer office or representative for further information.
For spectrometers without installation, you can easily install the instrument by
following the directions given in the table below.
If you intend to use accessories, for example a cell changer or sipper, refer to
Accessory Installation on page 39 to install these accessories.
Preparing the Working Area
For maximum stability and minimum maintenance observe the following
requirements when siting the instrument:
• A firm base free from vibration.
• Enough space around and underneath the instrument for efficient air
circulation.
• A constant temperature between 15 ºC and 35 ºC.
• Constant humidity between 20% and 80% relative humidity.
• An atmosphere free from dust and corrosive fumes.
• Keep out of direct sunlight. Illumination with diffuse lighting is ideal.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
