Lambda 20, Lambda 40 UV/Vis Spectrometers
10
• Servicing should be carried out only by a PerkinElmer service representative or
similarly authorized and trained person.
• Disconnect the instrument from all voltage sources before opening it for any
adjustment, replacement, maintenance, or repair. If, afterwards, the opened
instrument must be operated for further adjustment, maintenance, or repair, this
must only be done by a skilled person who is aware of the hazard involved.
• Use only fuses with the required current rating and of the specified type for
replacement. Do not use makeshift fuses or short-circuit the fuse holders.
• Whenever it is likely that the instrument is no longer electrically safe for use,
make the instrument inoperative and secure it against any unauthorized or
unintentional operation.
The instrument is likely to be electrically unsafe when it:
• Shows visible damage;
• Fails to perform the intended measurement;
• Has been subjected to prolonged storage under unfavorable conditions;
• Has been subjected to severe transport stresses.
Electromagnetic Compatibility (EMC)
European Union (EMC Directives)
This instrument has been designed and tested to meet the requirements of the EC
Directives 89/336/EEC and 92/31/EEC. It complies with the generic EMC standards
EN 50 081-1 (rf emissions) and EN 50 082-1 (immunity) for domestic, commercial,
and light industrial environments.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
