Basic Installation
29
NOTE: To prevent interferences caused by earth loops when operating with ancillary
instruments (printers, etc.), connect all components of the system to the same phase
of the electrical supply via a multisocket distributor.
Single Cell Holder
Figure 6 Single Cell Holder B0505071
NOTE: Depending on the spectrometer, the single cell holder can be installed in two
different positions in the sample compartment. Always install the holder such that
the arrow on the cell holder lines up with the center point on the baseplate (see
Installing the Cell Holder on page 30).
Locking screw
for horizontal
alignment
Vertical adjustment
screw
Milled post
Lifter
Locking screw
for horizontal
alignment
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com