Lambda 20, Lambda 40 UV/Vis Spectrometers
8
IEC 1010 Compliance
This instrument has been designed and tested in accordance with IEC 1010-1: Safety
requirements for electrical equipment for measurement, control, and laboratory use,
and Amendment 1 to this standard.
CSA Compliance
This instrument meets the Canadian Standards Association (CSA) Standard
CAN/CSA-C22.2 No. 1010.1-92: Laboratory Equipment.
UL Compliance
This instrument meets the Underwriter Laboratories (UL) Standard UL 3101-
1/Oct.93: Electrical Equipment for laboratory use, part 1: general requirements.
Electrical Protection
Insulation: Class I as defined in IEC 1010-1.
Installation Category: The instruments are able to withstand transient overvoltage
according to Installation Category II as defined in IEC 1010-1 and IEC 664.
Pollution Degree: The equipment will operate safely in environments that contain
non-conductive foreign matter and condensation up to Pollution Degree 2 as defined
in IEC 1010-1 and IEC 664.
Electrical Safety
To ensure satisfactory and safe operation of the instrument, it is essential that the
green/yellow lead of the line power cord is connected to true electrical earth
(ground).
If any part of the instrument is not installed by a PerkinElmer service representative,
make sure that the line power plug is wired correctly:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
