Basic Installation
35
NOTE: You should align microcells very carefully in the radiation beam by following the
procedures in Aligning the Single Cell Holder on page 31. When aligning
microcells, fill each cell with the minimum volume of liquid specified in the above
table to make sure that the liquid meniscus is not in the radiation beam.
Setting up the Printer
Activating the Internal Printer
If you want to use the internal printer, make sure the method
PRINTER CONFIG. is
set to
EPSON/INTERNAL
in Super User. On delivery, the default setting is
EPSON/INTERNAL.
Connecting an External Printer
You can use an external printer for hard-copy printouts of the analytical results.
PerkinElmer offers suitable printers; refer to the current price list for details.
To install an external printer:
1. Switch off the spectrometer, if it is on.
2. Set up the printer as given in the User’s Guide provided with the printer.
3. Configure the printer.
4. Connect the printer to the Parallel Port.
If you connect the printer to the second RS 232 interface, make sure the
Instrument Configuration method is set correctly in Super User.
5. Switch on the spectrometer and the printer to activate the new printer
configuration.
6. Make sure the method
PRINTER CONFIG.
is set correctly for the connected
printer in Super User.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
