Lambda 20, Lambda 40 UV/Vis Spectrometers
64
4. Slide the attenuator downwards into the beam.
5. Tighten the thumbscrew.
6. Follow the above procedure in reverse to slide the attenuator out of the beam.
7. Replace the lamp baffle using the reverse of the procedure described in step 2.
8. Close the lamp compartment.
Lamp Alignment Procedure
Due to the prealigned mounts, the alignment of lamps after installation is generally
so good that further alignment is not required.
Lamp energy
attenuator
Deuterium lamp
assembly
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
