Glossary
86
barcode reader component that scans the ID barcode mounted
on the sample plate
Note! The barcode reader position depends on
whether the ID barcode is placed on the long
or the short side of the plate.
barcode reader holder support onto which the barcode readers are
mounted
barcode reader module module assembly consisting of the barcode
reader holder and 1-2 barcode readers
basic frame rigid steel-bar case on which the instrument is
assembled
beamsplitter optical device to split the beam into two or
more separate rays. Optical device for
dividing a beam into two or more separate
beams.
bias mirror module the mirror module is used with the second
light source (TRF-laser). It has the aperture
offset from the center position (biased
excitation aperture) whereas mirror modules
used with light source 1 have the aperture in
the center. This bias mirror module comes in a
single mirror module version and a dual
mirror module version
bottom excitation cable optical fiber to guide the excitation light from
the light director assembly into the inlet
aperture of the mirror in the bottom measuring
head
bottom measuring head measuring head positioned below the x-y
conveyor
bottom measuring head
body
body section of the bottom measuring head ; it
embodies dedicated positions for different
modules
bottom mirror module
holder
holder of one manually replaceable mirror for
the bottom measuring head
CAN interface card PCI-bus based add-on card for PCs, which is
used for Controller Area Network (CAN)
protocol data communication
case assembly detachable outer cover of the instrument case
To Next Page
Loading...
Need help?
General