Perkins M216C - E268 Unexpected Engine Shutdown; E360 Low Engine Oil Pressure

KENR9126 107
Troubleshooting Section
None
Troubleshooting:
Refer to Syste
ms Operation, Testing and Adjusting
manual, “Fuel System - Inspect”.
Results:
•
OK – STOP.
i04018270
E268 Unexpected Engine
Shutdo wn
Conditions Which Generate This Code:
The Elect
ronic Control Module (ECM) detects an
unexpected engine shutdown under the following
conditions:
•
Engine is running
•
Remote s
hutdown switch is inactive (if equipped)
•
System shutdown is inactive
•
The ECM has detected zero engine speed. Refer
to Troubleshooting, “Event Codes” for the trip point.
System Response:
The El
ectronic Control Module (ECM) will log the
event.
Possi
ble Performance Effect:
•
None.
Troubleshooting:
Chec
k the Engine System
Check the air and fuel system. Verify that there are
no bl
ockages.
Expected Result:
A thorough inspection of the system has revealed
a problem.
Results:
•
OK
– There is a problem with the fuel system.
Repair: Make the necessary repairs. Verify that
th
e problem is resolved.
STOP.
•
Not OK – There is a problem with the air intake
system.
Repair: Repair the problem. Ensure that the repair
eliminates th
e problem.
STOP.
i04012509
E360 Low Engin e Oil Pressure
Conditions
Which Generate This Code:
The engine oil pressure has exceeded the trip point.
Refer to Tr
oubleshooting, “Event Codes” for the trip
point.
System Res
ponse:
360-1
The diagnostic lamp will flash while the event code
is active.
The Electronic Control Module (ECM) will generate
a157flash code that will be displayed via the
diagnos
tic lamp.
The ECM will generate a E360-1 event code.
The ECM will generate a SPN 100-FMI 17 event
code on the J1939 data link. The event code may be
displa
yed on a receiving device on the J1939 data
link.
The wa
rning will be canceled if the oil pressure rises
21 kPa (3 psi) above the set point for 20 seconds.
360-2
The diagnostic lamp will flash while the event code
is ac
tive.
The ECM will generate a 157 flash code that will be
disp
layed via the diagnostic lamp.
The ECM will generate a E360-2 event code.
The electronic service tool will display “Engine
Derate” in the first “Engine Status” box on any status
scr
een.
The ECM will generate a SPN 100-FMI 18 event
co
de on the J1939 data link. The event code may be
displayed on a receiving device on the J1939 data
link.
The derate will be canceled if the oil pressure rises
21 kPa (3 psi) above the set point for 20 seconds.