Perkins M216C - CID 0110 Fmi 04; CID 0127 Fmi 03; CID 0127 Fmi 04

88 KENR9126
Troubleshooting Section
The ECM will default to 90 °C (194 °F) for engine
coolant t emper
ature. “Voltage Above Normal” will
be displayed next to the status for “Engine Coolant
Temperature” on the electronic service tool.
Possible Performance Effect:
•
Poor stabili
ty
•
Poor cold running
•
White smoke
Troublesho
oting:
The diagnostic code will detect an excessively high
voltage fr
om the engine coolant temperature sensor.
Perform the following diagnostic procedure: “Engine
Temperatu
re Sensor Open or Short Circuit - Test”
Results:
•
OK – STOP.
i04015769
CID 0110 FMI 04
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the
following conditions:
•
The signal voltage from the engine coolant
temperature sensor is less than 0.2 VDC for more
than 8
seconds.
•
The ECM has been powered for at least 2 seconds.
•
Diagnostic code 0168-01 is not active.
Syst
em Response:
The ECM will default to 90 °C (194 °F) for engine
cool
ant temperature. “Voltage Below Normal” will
be displayed next to the status for “Engine Coolant
Temperature” on the electronic service tool.
If equipped, the diagnostic light will come on. An
active diagnostic code will be generated after 8
sec
onds. The diagnostic code will be logged if the
engine has been operating for more than 7 minutes.
Po
ssible Performance Effe ct:
•
Poor stability
•
Poor cold running
•
W
hite smoke
Troubleshooting:
The diagnostic code will detect an excessively low
voltage from the engine coolant temperature sensor.
Perform the following diagnostic procedure: “Engine
Temperature Sensor Open or Short Circuit - Test”
Results:
•
OK – STOP.
i04012454
CID 0127 FMI
03
Conditions Which Gen erate This Code:
The signal
from the marine transmission oil pressure
sensor is above normal.
System Re
sponse:
The Electronic Control Module (ECM) will log the
diagnos
tic code. The ECM flags marine transmission
oil pressure as invalid data.
Possibl
e Performance Effect:
•
There are no performance effects.
Troubleshooting:
Perfor
m the following diagnostic procedure: “Engine
Pressure Sensor Open or Short Circuit - Test”
Resul
ts:
•
OK – STOP.
i040
12455
CID 0127 FMI 04
Con
ditions Which Gen erate This Code:
The signal from the marine transmission oil pressure
sen
sor is below normal.
System Response:
The Electronic Control Module (ECM) will log the
diagnostic code. The ECM flags marine transmission
oi
l pressure as invalid data.
Possible Pe rformance Effect:
•
There are no performance effects.