Perma PRO 250 - Impulse Mode Via the Connected Control System; Replacement of the PRO LC Unit

permaPROC-18-
6.10 Impulse Mode via the Connected Control System
DischargeoflubricatorPROCcanalsobetriggeredviatheattachedcontrolsystem.
Inthiscase,thelubricatordischarges0.5cm
3
lubricanttothelubricationpointeverytimeitisswitchedon.
Forthis,youhavetoswitchonthesupplyvoltageviayourcontrolsystemforatleast14minutesandthenyou
havetoswitchitoffforatleast20seconds.
Theminimumoperatingtimeof14minutesisduetothepossibilitytoconnectthepermaPROCtothedistributor
permaMP-6.Thisdistributorisabletosupplylubricanttouptosixlubricationpoints.
Thismeansthatthedistributorneedsaminimumoperatingtimeof14minutestobeabletosupply1.0cm
3

lubricanttoeveryopendistributoroutlet.
Ifoperatedasasingle-pointlubricationsystem,theminimumoperatingtimeisreducedto1minuteandthe
dischargeamountperimpulse=0.5cm
3
.
ForanactivationofthepermaPROClubricatorviayourcontrolsystem,youneedtosetthelubricator
toimpulsemodeviathecongurationmenu(refertochapter6.8).
Forthis,youhavetoselectthesetting“ “Daysinthesettingmode“Days”(refertogure17).

88
Outlets
1
3
2
4
5
6
Days
Weeks
Months
%Vol.
LC2500LC2500
Confi g.
TimeTime PIN
Config.
Time
Days
gure17
7. Replacement of the PRO LC unit
The Following Must Always Be Taken into Account
IfthereplacementofanemptyPROLCunitbecomesnecessary,itwillbeindicatedbyasimultaneous
blinkingoftheredandthegreenLED.Additionally,thedisplayindicatesthatthePROLCunitisempty
(refertogure18).
IfthePROLCunitisempty,theconnectedcontrolsystemofyourequipmentreceivesa“Low”signalanda
malfunctionisindicated.

%Vol.
LC 500
 gure18
If you replace the PRO LC unit by an PRO LC unit of a different size, a corresponding protection cover
(refer to ”Accessories and Spare Parts”) must be used.

Since the drive unit and the control board must be protected against moisture, an exchange may only
be carried out in dry conditions!
AftertheinstallationofthenewPROLCunit,thecontrolsystemcontinuestooperateusingthepreviouslyvalid
settingofthedischargeperiod.